Plumbing and leak help across Essex • 07939 013120
Home / Advice / Leaking overflow pipe

Leaks & warning pipes

Water dripping from an overflow pipe: what does it mean?

A warning pipe is doing its job by showing that a cistern or tank is overfilling. The dripping may look minor, but the cause still needs finding and repairing.

By Ricky Cole • Published 20 November 2026 • 6-minute read

Water running from a small pipe through an outside wall is often described as an overflow. On older systems, it can be the visible warning that a toilet cistern or water-storage cistern is filling higher than it should. Modern toilets commonly send excess water into the pan instead, so you may notice a constant trickle down the back of the bowl rather than water outside.

Never cap, plug or block a dripping warning pipe. It provides a safe route for excess water and alerts you to a fault. Blocking it could allow water to spill inside the property.

Why does an overflow pipe start dripping?

A cistern normally uses a float-operated inlet valve to stop the water when it reaches the correct level. If the valve is worn, obstructed or incorrectly adjusted, or the float sticks or becomes damaged, water may continue entering. The level then reaches the warning pipe or internal overflow.

In a toilet, a separate flush-valve fault can also let clean water escape into the bowl. The inlet valve then keeps refilling the cistern, which is why a toilet may refill by itself long after anyone has used it.

Work out where the water may be coming from

First note where the pipe exits and when it drips. A pipe near a bathroom may be connected to an older toilet cistern. One higher up, below the eaves, may be linked to a storage cistern in the loft. Do not assume the source from the outside position alone: pipe routes can change inside the building.

If the drip starts after a particular toilet is flushed, listen for continued filling and look for movement at the back of the pan. WaterSafe and Thames Water both advise that a toilet leak may appear as trickling, rippling or flowing water in the bowl.

Only inspect a cistern if it is safely accessible. Do not climb into an unboarded loft, balance on furniture or remove a heavy concealed-cistern panel. A photograph or short video of the drip and its location can help a plumber identify the likely source.

Safe checks you can make

  • Check whether the water is continuous or only appears after a toilet, bath or other fitting is used.
  • Listen for a toilet refilling when it has not recently been flushed.
  • For a modern toilet, wait 30 minutes after flushing, dry the back of the pan and place dry toilet tissue there. If it becomes wet without the toilet being used, water is escaping into the bowl.
  • If a removable toilet-cistern lid lifts easily and safely, look without touching to see whether water is entering the overflow or whether the float is trapped.
  • Check for damp ceilings, staining or water around the cistern, as this may mean water is escaping somewhere other than the warning pipe.

Do not bend a float arm, dismantle an inlet valve or disturb old fittings unless you are responsible for the property and know the correct procedure for that particular fitting. Plastic components can become brittle, and a small drip can become a larger leak if a connection breaks.

Should you turn the water off?

A slow outside drip is not usually the same as a burst pipe, but it should not be ignored. If the flow becomes heavy, water is entering the home, a ceiling is wet or bulging, or the cistern itself is overflowing, turn off the water using the correct local isolation valve or the main internal stop tap if you can do so safely.

Turn a valve gently in the normal closing direction. If it is seized, badly corroded or will not move with light hand pressure, do not use tools or force it. Call for help instead. Keep people away from wet electrical fittings and do not touch switches or equipment in the affected area.

Why an overflow should not be left dripping

Even a small continuous flow wastes treated water and can increase a metered bill. WaterSafe says a leaking toilet can waste hundreds of litres a day. Outside dripping can also stain walls, keep brickwork wet and create a slippery or icy patch in cold weather.

The visible water is a symptom rather than the repair. The lasting fix may involve cleaning, adjusting or replacing the correct inlet, float or flush-valve component and then checking that the water shuts off at the right level.

What should tenants and landlords do?

Tenants should report the problem promptly rather than blocking the pipe or opening landlord-owned plumbing. Include a photo or video, the room nearest the pipe, whether the flow is constant and what was being used when it started. Say immediately if there is damp indoors or water near electrics.

Landlords and letting agents should arrange investigation before water damage or a high bill develops. At changeover checks, run each toilet, wait for the cistern to refill and confirm that filling stops. Also check the back of the pan for a silent trickle and look outside for active warning pipes.

When should you call a plumber?

  • The warning pipe runs continuously or the flow is getting heavier.
  • A toilet keeps refilling, water moves in the pan or the tissue test confirms a leak.
  • You cannot identify which cistern or tank is overfilling.
  • The isolation valve is seized, damaged or inaccessible.
  • There is damp, staining, a bulging ceiling or water inside the property.
  • The fault returns after an adjustment or previous repair.

For leaking overflow pipes and cistern faults across Essex, call Ricky on 07939 013120 or email Essexemergencyplumbing@gmail.com. Tell us where the pipe exits, whether the flow is constant and if you can hear a toilet or tank refilling.

Trusted further guidance